Hi Bill,
I know this was addressed to the other David, but will this resolve the issue I (and others) have run into using Split (rather than Fake It)? 73, David, K2DBK From: Bill Somerville <[email protected]> Sent: Tuesday, May 26, 2020 5:10 PM To: [email protected] Subject: Re: [wsjt-devel] WSJT-X 2.2.0 rc2 Hi Mike and David, my latest Hamlib patch should sort this out. The issue was a regression, caused by me, where PTT using RTS or DTR on a serial port, not also used for CAT, was messed up. 73 Bill G4WJS. On 26/05/2020 22:05, Black Michael via wsjt-devel wrote: Do you have CAT control turned on? We're still trying to figure out what's causing this. Mike W9MDB On Tuesday, May 26, 2020, 03:33:25 AM CDT, David M. Boyter <mailto:[email protected]> <[email protected]> wrote: Morning I get the same as I use 232 for PTT. Happened about every 2nd transmission And "tune" button same problem 73 David AE5SB _____ From: Charles Suckling <mailto:[email protected]> <[email protected]> Sent: Tuesday, May 26, 2020 1:35 AM To: WSJT software development <mailto:[email protected]> <[email protected]> Subject: Re: [wsjt-devel] WSJT-X 2.2.0 rc2 Hi Allan I see exactly the same as you with RS232 PTT. I hadn't monitored the state of the Test PTT button. As you observe, if this turns red during a receive period then the following transmission has no audio. If the button does not turn red during a receive period the following transmission is OK. Watched the behaviour for a number of periods and this seems to be consistent. 73 Charlie G3WDG On Tue, 26 May 2020 at 07:10, Allan VK4QG <[email protected] <mailto:[email protected]> > wrote: Gentlemen, To start with, my system is a Dell 1650, i7 @3.40 GHz, 16GB RAM, W10 pro 64bit. I do not use CAT but instead use RTS on COM1 for opto-isolated PTT and XFR isolation for audio in and out of the sound-card, and have done so without issue since 2006. Two problems : - 1. I have found with rc2 that occasionally PTT is not working at all and when it does there is often no TX audio present either. While monitoring 'Radio' under 'Settings' I have noticed when this occurs, after a successful transmission about two seconds into the RX period the 'Test PTT' button turns red and from that point there is no PTT in the following TX period. After a time it appears to clear itself and PTT in the following period with or without TX audio. 2. I am still getting numerous false decodes. Most of these contain '/R' and '<.....>'. I am not using AP. Many thanks, Allan - VK4QG
_______________________________________________ wsjt-devel mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/wsjt-devel
