I understand that but the problem is wsjtx TX or playback never shows up
in pavucontrol Playback tab. wsjtx Rx does show up in the Recording tab
OK
73 Glenn VE9GJ
On 2021-02-17 12:25, Topher Petty wrote:
in Pulseaudio, you need to select the input and output sources using
"pavucontrol".
Just above and to the left of the wsjt-x volume control and level in
pavucontrol the device you're sending to is shown. Click that and
select your radio's sound device.
You should, then, see the radio start transmitting.
73 de AI8W, Chris
-----BEGIN GEEK CODE BLOCK-----
Version: 3.1
GCS/CM/CC/E/IT/TW d-@ s+:+ !a C++$@ UBLVSCX*++++(on)$>$ P++>$ L+++$
E+@ W++>$ N+++ o+@ K+++ w@ O+@ M-@ V@>$ PS+@ PE@ Y+ PGP++ t+ 5+ X++
R@* tv++ b+>$ DI++ D+ G++ e h r+++ y+++
------END GEEK CODE BLOCK------
On Wed, Feb 17, 2021 at 11:12 AM <ve...@napan.com> wrote:
Hi
I have been struggling to get wsjtx working on my Ubuntu 20.04 64bit
Desktop. When I started I had version 2.1.1 then upgraded to 2.3.0
but
there was no change in behavior. Rig is a FT991A using builtin USB
sound
device. Cat works OK. I can set Audio to Pulse for both Rx and TX
in
wsjtx settings. Rx now works and decodes OK. I can switch modes no
problem. I can see wsjtx in the recording tab of pavucontrol. If
attempt to Tx via the Tune button (or Tx enable) the rig will switch
to
TX but there is no Tx audio. wsjtx never shows up in pavucontrol's
Playback tab. If I toggle the tune button (or Halt) the rig will go
back
to Rx but wsjtx will never decode again. The waterfall is frozen but
the
sequence timer progress bar is still working. Toggling the Tune
button
will continue to put the Rig in and out of TX. The only way to
decode
again is to kill wsjtx and start over. All is OK until Tx is
attempted.
Some observations.
It is not RF related. If I disable PTT in wsjtx so the rig never
actually goes to TX changes nothing.
After I attempt to Tx and quit wsjtx via the "X" or File-->Exit the
Gui
will close but a wsjtx process continues to run and has to be
killed.
If I close wsjtx before a Tx attempt it closes cleanly.
I start wsjtx in a terminal and see no hints of what could be wrong.
Fldigi via pulse is working fine.
Same issue with a TS-590SG.
Is there any way to get wsjtx to create some debug logs to trace the
source of the problem?
Any suggestions?
Thanks
73 Glenn VE9GJ
_______________________________________________
wsjt-devel mailing list
wsjt-devel@lists.sourceforge.net
https://lists.sourceforge.net/lists/listinfo/wsjt-devel
_______________________________________________
wsjt-devel mailing list
wsjt-devel@lists.sourceforge.net
https://lists.sourceforge.net/lists/listinfo/wsjt-devel
_______________________________________________
wsjt-devel mailing list
wsjt-devel@lists.sourceforge.net
https://lists.sourceforge.net/lists/listinfo/wsjt-devel
