On 30/09/2021 16:35, Marco Calistri wrote:
Il 30/09/21 10:58, Bill Somerville via wsjt-devel ha scritto:
On 30/09/2021 14:36, Marco Calistri via wsjt-devel wrote:
CQRLOG now has been compiled with the */chkvfo/* feature, settings
adjusted as suggested but again _*no AFSK going to radio rear data
connector if I select mode USB in WSJT-X*_, in order to transmit an
FT8 signal _*I *__*need to select DIG mode*_.
Then, the only possible solution *IMHO* should be that Hamlib being
modified accordingly in order to permits AFSK being usable for rear
data connector in SSB too and not just in DIG mode.
Marco,
DIG mode is the correct rig mode setting for AFSK digimodes when
using the FT-100.
There is no facility to select the Tx audio source other than the rig
mode settings with the FT-100.
73
Bill
G4WJS.
Hey Bill!
I've not doubts about what you say, but unluckily, due some reasons
I'm not aware of, if I select Mode Data/Pkt in WSJT-X, it looks like
nobody station being able to listen and consequently to answer to my
calls.
Probably when I set Data/Pkt my radio transmit on a little shifted
frequency out of the center of the standard transmission FT8 frequency
and this unallow my signal to be heard.
---
*73 de Marco, PY1ZRJ (former IK5BCU)*
Hi Marco,
which DIG mode (AFSK MODE) have you set in your rig's menu? Have you set
the PKT DISPLAY menu item to zero to remove any VFO dial frequency
offset in PCt-U mode?
73
Bill
G4WJS.
_______________________________________________
wsjt-devel mailing list
wsjt-devel@lists.sourceforge.net
https://lists.sourceforge.net/lists/listinfo/wsjt-devel
