Hi Andy,
On mu Kubuntu machine the TX stream only shows up in the PulseAudio volume control utility when actually transmitting. An interesting quirk over multiple versions of Kubuntu is that I have to select different "paths" for TX and RX audio, i.e. one to a pulse device and the other to an alsa device, in WSJTX or it simply will not work. It may be because I use two different sound cards but I won't know for sure until I eventually get TX moved over to my Tascam US-100. I hope this helps. 73 -Jim NU0C On Fri, 17 May 2024 13:23:44 +0000 (UTC) Andrew Neumeier via wsjt-devel <wsjt-devel@lists.sourceforge.net> wrote: > Good Morning, > Perhaps I can get some insight from the group on a issue here. > > Recently obtained a xggcomm Digimode 3 interface. I am intending to use it > with a Ten Tec Orion. It was initially connected to a older machine here, > and using WSJTX, worked just fine with the Orion. On connectionto a much > newer computer, there is no audio output to the rig. On the newer machine, > the pull-down list in the Audio settings shows the C-Media sound card in the > Digimode 3, but only on the Input side, not the Output side. Both are seen > when using the older computer. So, I can receive just fine using the > Digimode 3 on the new computer, just no audio out, no xmit. > > Both computers run WSJTX version 2.6.1, and both machines run Kubuntu 22.04. > Running the lsusb command and getting detail on the C-Media card, on the > newer computer, shows that the o/s sees both the input and output sides of > the C-Media card. > I'm also a member of the dialout group,it's one of the first things I > checked. > > Running out of ideas here, anyone have a idea that might help? > 73,Andy, ka2uqw _______________________________________________ wsjt-devel mailing list wsjt-devel@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/wsjt-devel
