Also set the output device whilst sending a test from wsjtx, It only
shows in Volume control (pavucontrol) when active sending
then you can set device and level.
On 18/5/24 01:12, Adrian wrote:
sudo apt install pavucontrol
if you don't have it already ?
See https://forums.linuxmint.com/viewtopic.php?t=327359
i run the same interface on Debian here.
Use pulse in wsjtx audio select choices and then select the wsjtx
assigned audio in pavucontrol (Volume Control) for pulseaudio.
It will be obvious when you see the wsjtx device or QTpulseaudio
device (if you select device direct in wsjtx audio) with drop down choice.
73
vk4tux
On 17/5/24 23:23, Andrew Neumeier via wsjt-devel wrote:
Good Morning,
Perhaps I can get some insight from the group on a issue here.
Recently obtained a xggcomm Digimode 3 interface. I am intending to
use it with a Ten Tec Orion. It was initially connected to a older
machine here, and using WSJTX, worked just fine with the Orion. On
connection
to a much newer computer, there is no audio output to the rig. On
the newer machine, the pull-down list in the Audio settings shows the
C-Media sound card in the Digimode 3, but only on the Input side, not
the Output side. Both are seen when using the older computer. So, I
can receive just fine using the Digimode 3 on the new computer, just
no audio out, no xmit.
Both computers run WSJTX version 2.6.1, and both machines run Kubuntu
22.04. Running the lsusb command and getting detail on the C-Media
card, on the newer computer, shows that the o/s sees both the input
and output sides of the C-Media card.
I'm also a member of the dialout group,it's one of the first things I
checked.
Running out of ideas here, anyone have a idea that might help?
73,
Andy, ka2uqw
_______________________________________________
wsjt-devel mailing list
wsjt-devel@lists.sourceforge.net
https://lists.sourceforge.net/lists/listinfo/wsjt-devel
_______________________________________________
wsjt-devel mailing list
wsjt-devel@lists.sourceforge.net
https://lists.sourceforge.net/lists/listinfo/wsjt-devel
