All,
I'm closer to getting this to work. I've made a new cable matching the
pinouts, and this time when I view the option of "view incoming data"
all I see is a repeat about 20+ times of a string:
O->TNC: ?
I've googled for this and dont come up with anything. Anyone have idea's?
Thanks again,
r
David Flood wrote:
My first suggestion would be to make sure you are plugged into the PC/Comm
jack. It sounds like you've pluged into the Data jack instead and are
triggering the PTT line on that jack.
From looking at the online manual (and that's all I can afford right now) both
jacks have the same number of outside pins so it would be easy to plug the same
plug into both. The PC/Comm jack adds a center pin for ground that isn't there
on the Data jack.
Dave
KD7MYC
-----Original Message-----
From: Russell Handorf <[EMAIL PROTECTED]>
Sent: Dec 12, 2007 9:04 AM
To: [email protected]
Subject: [Xastir] Xastir and TM-D710A
Greetings all,
I'm trying to get my Kenwood TM-D710A and Xastir to work together. I
followed the instructions for just a serial connection only (/dev/ttyS0)
and start the port. My radio immediately begins to transmit *dead air*
and doesnt stop until I remove the serial cable.
_______________________________________________
Xastir mailing list
[email protected]
http://lists.xastir.org/cgi-bin/mailman/listinfo/xastir
