Thanks David,
I think it's that I had it configged for 9600 baud, not 1200. When I use
the internal TNC on the radio for 9600 Baud, I have no updates where as
1200 shows all the traffic.
The problem is when I try to tell the radio to use a different port
speed on the com port. 9600 baud is the lowest I can go! My options are
9600, 19200, 38400, and 57600.
Am I just SOoL? I'm about to call Kenwood to see if I can put it in a
lower speed on the Comm port.
Thanks
David Flood wrote:
Try kicking down your serial speed on both the radio and the computer. You
also might want to make sure that all available serial wires are connected
not just the two data and the ground.
-----Original Message-----
From: Russell Handorf [mailto:[EMAIL PROTECTED]
Sent: Sunday, December 16, 2007 19:34
To: David Flood
Cc: [email protected]
Subject: Re: [Xastir] Xastir and TM-D710A
David,
Thanks for the suggestion. Unfortunately, this is with the PC's built in
serial port. I do have two USB to Serial adapters; I'll give them a try,
r
David Flood wrote:
I've seen this on my D700 and my Alinco 135 when I tried to use a really
old
usb to serial adapter that couldn't handle the handshaking.
I'd first try to find a computer with a real serial port. Failing that,
start trying different usb to serial adapters and hope you find one that
works.
Dave
KD7MYC
-----Original Message-----
From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED] On
Behalf
Of Russell Handorf
Sent: Sunday, December 16, 2007 18:39
To: [email protected]
Subject: Re: [Xastir] Xastir and TM-D710A
all I see is a repeat about 20+ times of a string:
O->TNC: ?
_______________________________________________
Xastir mailing list
[email protected]
http://lists.xastir.org/cgi-bin/mailman/listinfo/xastir
