The patch was based off the FIXME comment in the code [which suggested
replacing 11 with the boundary for the regulatory domain]. I'll take a
look at the vendors driver and see about modifying the patch to fit
more with its logic or just limmiting it to the FCC regulatory domain.

On 10/30/06, Uli Kunitz <[EMAIL PROTECTED]> wrote:
> Johannes Berg wrote:
> >> I'm not so sure about this. This patching might be US-specific and we
> >> cannot simply apply the setting for top channel of another domain
> >> instead of channel 11. One option would be to set the value only under
> >> the US regulatory domain.
> >
> > ??
> > What the patch does is replace the top channel which is hardcoded to 11
> > by the top channel given by the current regulatory domain. How can that
> > be wrong? Except that you may want to init the regulatory domain from
> > the EEPROM but I'm not sure how the ieee80211 code works wrt. that.
> >
> > johannes
>
> The problem is not so much that I don't trust the geo code, but whether
> setting the register to that band-edge value for a higher channel is
> the right thing to do. It looks like that this is a hack for FFC
> compliance. Therefore I suggest to patch CR128 only
> for the US regulatory domain.
>
> Here is the code from the GPL vendor driver (zdhw.c):
>
>     if (pObj->HWFeature & BIT_21)  //6321 for FCC regulation, enabled 
> HWFeature 6M band edge bit (for AL2230, AL2230S)
>      {
>          if (ChannelNo == 1 || ChannelNo == 11)  //MARK_003, band edge, these 
> may depend on PCB layout
>          {
>              pObj->SetReg(reg, ZD_CR128, 0x12);
>              pObj->SetReg(reg, ZD_CR129, 0x12);
>              pObj->SetReg(reg, ZD_CR130, 0x10);
>              pObj->SetReg(reg, ZD_CR47, 0x1E);
>          }
>          else //(ChannelNo 2 ~ 10, 12 ~ 14)
>          {
>              pObj->SetReg(reg, ZD_CR128, 0x14);
>              pObj->SetReg(reg, ZD_CR129, 0x12);
>              pObj->SetReg(reg, ZD_CR130, 0x10);
>              pObj->SetReg(reg, ZD_CR47, 0x1E);
>          }
>      }
>
> The patch from Holden would set ZD_CR128 to 0x12 for the highest channel,
> which would not reflect the logic of the vendor driver.
>
> Kind regards,
>
> Uli
>
> --
> Uli Kunitz ([EMAIL PROTECTED])
> -
> To unsubscribe from this list: send the line "unsubscribe netdev" in
> the body of a message to [EMAIL PROTECTED]
> More majordomo info at  http://vger.kernel.org/majordomo-info.html
>


-- 
Cell: 613-276-1645

-------------------------------------------------------------------------
Using Tomcat but need to do more? Need to support web services, security?
Get stuff done quickly with pre-integrated technology to make your job easier
Download IBM WebSphere Application Server v.1.0.1 based on Apache Geronimo
http://sel.as-us.falkag.net/sel?cmd=lnk&kid=120709&bid=263057&dat=121642
_______________________________________________
Zd1211-devs mailing list - http://zd1211.ath.cx/
Unsubscribe: https://lists.sourceforge.net/lists/listinfo/zd1211-devs

Reply via email to