All boards tested. There were a few minor errors in mounting of PCB 
that we corrected.
All HDMI inputs work, VGA and DVI outputs work. Ethernet works.
DDC channel wasn't tested.

Regards,
Adrian

On Wed 27 Nov 2013 19:45:41 CET, Adrian Byszuk wrote:
> Now it looks much better. I'm still not able to get EDID information (will 
> look into that),
> but manually enabling HDMI output seems to work and I can see such output on 
> console:
> dvisampler0: ph:   8   13    5 // charsync:111 [4 4 4] // WER:  0   0   0 // 
> chansync:1 // res:1024x768
> dvisampler0: ph:   9   14    6 // charsync:111 [4 4 4] // WER:  0   0   0 // 
> chansync:1 // res:1024x768
> dvisampler0: ph:   8   13    7 // charsync:111 [4 4 4] // WER:  0   0   0 // 
> chansync:1 // res:1024x768
> dvisampler0: ph:   7   14    6 // charsync:111 [4 4 4] // WER:  0   0   0 // 
> chansync:1 // res:1024x768
>
> I'll continue testing tomorrow.
>
> Adrian
>
> On 27/11/13 16:21, Sébastien Bourdeauducq wrote:
>> On 11/27/2013 03:55 PM, Adrian Byszuk wrote:
>>>>> Does it keep printing that (it should repeat at ~1Hz), or does it go
>>>>> into the "disconnected" state immediately after?
>>> It goes into disconnected state immediately after. Basically screen is
>>> flooded with these messages.
>>
>> That could be the Spartan-6 PLL phantom lock "feature". I guess you did
>> not have the HDMI output enabled on your laptop?
>> I have added a filter later on the PLL lock output to fix this bug. The
>> new binaries below should not have the problem.
>>
>>>> This is weird... Don't you see any other messages before the freeze?
>>>
>>> No, it's just that it freezes suddenly. I've checked this with another
>>> board and I have the same symptoms. It even freezes much sooner, always
>>> after 'Executing booted program.' line.
>>
>> I just tried this exact binary on a board I have and it also tends to be
>> very unstable, even though it does not crash immediately after startup
>> here. It could be a ISE timing model/P&R intermittent bug that affected
>> that bitstream, it happens sometimes...
>>
>> I have compiled new binaries that hopefully will address both problems
>> (you need to reflash bios.bin):
>> http://milkymist.org/mixxeo_binaries_2.tar.bz2
>> I did not trust ISE this time and verified that everything is stable
>> enough on the board...
>>
>> Press capital 'D' after videomixer.bin is loaded to enable HDMI
>> debugging messages. You can also press 'm' to display the memory
>> bandwidth statistics (it does not do so every second like the old
>> firmware did).
>>
>> Additionally, you will find the memtest.bin firmware that you can
>> netboot to stress-test the SDRAM.
>>
>> Sebastien
>>
_______________________________________________
Devel mailing list
Devel@lists.milkymist.org
https://ssl.serverraum.org/lists/listinfo/devel

Reply via email to