If you could list the items that are not correct with the corrected
information I can work on them. I searched for tons of places but
nothing showed up... also if your looking at the html documents online
the url would help me find the document with the error much faster.
Like this:
http://linuxcnc.org/docs/2.8/html/config/ini-config.html
The section would be best like this:
http://linuxcnc.org/docs/2.8/html/config/ini-config.html#_axis__lt_letter_gt_section
JT
On 2/4/2021 3:33 PM, Jon Elson wrote:
On 02/04/2021 02:42 PM, Jon Elson wrote:
And, the second one is that before homing, my jog pendant works
fine. AFTER homing all axes,
it does not cause movement. I looked at :
joint.0.jog-enable it goes true when the jog enable button is pressed
joint.0.jog-scale it is 2.5x10^-5 (-r ^-6 or ^-7) depending on the
jog rate selector
joint.0.jog-counts it shows a large integer which changes as the jog
dial is rotated.
Aha, of course, you have to send the jogging command to both
joint.0... and axis.x...
if you want jogging in both modes. Which brings me to the point that
the docs need a
MAJOR update in regard to the axis/joint split. There are tons of
places in the associated
docs where they still show the old 2.7 behavior of things.
Jon
_______________________________________________
Emc-developers mailing list
[email protected]
https://lists.sourceforge.net/lists/listinfo/emc-developers
_______________________________________________
Emc-developers mailing list
[email protected]
https://lists.sourceforge.net/lists/listinfo/emc-developers
