Hi, I have the same setup with solar controller and analog temp sensors. But instead of tampering with that one i use ordinary ds18s20 (1wire digi temp) strapped to both the incoming and outgoing side of the solar heating system. The sensors seems to cope fine with the high temps. (had an incident with melting insulation on connecting cables but that won't happen again :)
Works as a "good enough" solution for me /Par 26 maj 2011 kl. 20:14 skrev Pedro Côrte-Real <[email protected]>: > Thanks for all the suggestions. Since this needs to be connected to > the solar installation controller primarily and the 1wire is just a > reading mostly to satisfy curiosity, I'll have to figure out how to > make both work. I can potentially open up the controller itself and > see if I can tap into it's own measurement. There may be a voltage > somewhere I can. > > Thanks again, > > Pedro > > ------------------------------------------------------------------------------ > vRanger cuts backup time in half-while increasing security. > With the market-leading solution for virtual backup and recovery, > you get blazing-fast, flexible, and affordable data protection. > Download your free trial now. > http://p.sf.net/sfu/quest-d2dcopy1 > _______________________________________________ > Owfs-developers mailing list > [email protected] > https://lists.sourceforge.net/lists/listinfo/owfs-developers ------------------------------------------------------------------------------ vRanger cuts backup time in half-while increasing security. With the market-leading solution for virtual backup and recovery, you get blazing-fast, flexible, and affordable data protection. Download your free trial now. http://p.sf.net/sfu/quest-d2dcopy1 _______________________________________________ Owfs-developers mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/owfs-developers
