On Sun, May 29, 2011 at 11:15:42AM +0100, Mick Sulley wrote: > I use DS18S20's to control a solar heating setup, sensors in the panels > and on the pipework, all read by owfs into a python program. The > program uses X10 to drive the outputs to pumps and valve, but I am > currently changing over to use 1-wire outputs as well as I have had some > trouble with X10. It heats hot water and also a heat exchanger for a pool. > > I had a melt down a while back, the 1-wire was fine, I used high temp > cables for the sensors in the panels, I think it is only rated to 95 C > but the panels went up to 125 C and the sensor were OK, the pipe > insulation was not. > > Mick
Your setup sounds pretty interesting, do you have a web page describing it all in detail? njh ------------------------------------------------------------------------------ vRanger cuts backup time in half-while increasing security. With the market-leading solution for virtual backup and recovery, you get blazing-fast, flexible, and affordable data protection. Download your free trial now. http://p.sf.net/sfu/quest-d2dcopy1 _______________________________________________ Owfs-developers mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/owfs-developers
