Unless they back out of the PowerGEN conference in December, they should have a running system on display along with other OEMS using their engine. I am not ready to give them $50K
On Tue, Aug 14, 2012 at 11:14 AM, Kelley Trezise <ktrez2...@ssvecnet.com>wrote: > ** > Until I see an energy balance on the engine or they run this in a closed > loop, generating the power for the spark and such, and produce a > significant amount of work out over a significant amount of time they have > nothing. Don't buy a thing until you have proof that it works. > > ----- Original Message ----- > *From:* Chemical Engineer <cheme...@gmail.com> > *To:* vortex-l@eskimo.com > *Sent:* Tuesday, August 14, 2012 3:18 AM > *Subject:* [Vo]:Re: ProdEngAssemble.avi > > At 2:30 of this video they mention aligning the holes shown machined on > the outside of each cylinder to the top for access to the coils for wiring, > etc. I believe they mount a circuit board for each cylinder atop/near > each hole to access the coils to supply control power. > > They do not show the coils inside and i am not sure how they seal it all > up. Another video shows the compression coil directly around the target > spot of the plugs. A containment coil is supposedly around the rest of the > piston. > >> >> ProdEngAssemble.avi<http://www.youtube.com/watch?v=AqFgM8osjLE&feature=youtube_gdata_player> >> >> >> Sent from my iPad >> >