Hi Chuck,
Is it happening on a line of code which is split up in several lines ('\')?
I've seen this happening a number of times. Mainly quitting and restarting 4D
is enhough to solve this issue. You might try to remove the slash chars, set a
breakpoint at the remaining line and remove it right away and then split your
line again.
HTH
Koen
> Op 7 feb. 2019, om 21:39 heeft Chuck Miller via 4D_Tech
> <[email protected]> het volgende geschreven:
>
> I have an object method that shows no break points either in the method or
> when I show break points, yet it continues to stop at a particular line of
> code and it is annoying. Any ideas out there what it might be.
--------------------
Compass bvba
Koen Van Hooreweghe
Kloosterstraat 65
9910 Aalter
Belgium
tel +32 495 511.653
**********************************************************************
4D Internet Users Group (4D iNUG)
Archive: http://lists.4d.com/archives.html
Options: https://lists.4d.com/mailman/options/4d_tech
Unsub: mailto:[email protected]
**********************************************************************
