I wouldn't put that in any area where weather could get at it. Just
asking for trouble. It needs to be sealed from
moisture/condensate/water. Perhaps half a ton of silicon grease
temporarily?
On 1/10/23 09:59, Chuck McCown via AF wrote:
I build a piece of industrial equipment. Currently the motion control
PCB is in the steering column. I am thinking of potting it and
putting it underneath the chassis. Easy to get to etc. But what kind
of connector should I use? Flying leads coming out of the potting
compound into a cannon type connector? Hate to use any connector that
is non ip67, so phoenix plugs are out.
Not sure I am going to do this but we are kicking it around. I might
just leave it where it is. It has phoenix connectors now with wires
and ferules going to screw down terminals etc.
Best Regards,
Chuck McCown
McCown Technology Corporation
8401 N Commerce Dr
Lake Point, Utah 84074
801-250-9503 Office
435-830-4306 Cell
www.mccowntech.com
www.microtrench.pro
www.terabitnetworks.com
--
AF mailing list
[email protected]
http://af.afmug.com/mailman/listinfo/af_af.afmug.com
