Yes, there are issues I'm seeing with AutoSync on all bands with
13.2/13.2.1. But 3GHz is... different, and I don't know why. I have a
couple APs on a SyncInjector and some single APs on parasitic pipes. I
thought it was just the SyncInjector or something else at the site until
I started seeing the same problems on the parasitics after just a few
days of install at new sites. They all have the on-board GPS disabled
too. Random LBT hits, the APs show inSync and outSync counts but no
lost/acquired timing messages in the event log, and the SyncInjector
says nothing happened, SMs going crazy losing session, APs reporting SMs
out of range when things go nuts and I have to reboot the AP(s).
AutoSync+FreeRun get stuck in FreeRun. Something in the FPGA code or
some other logic screwed up. I have no idea, so I hope Cambium can
figure it out.
On 3/2/2015 12:25 PM, Bill Prince wrote:
Not this one. This one is running a pair of PMP450s in 5 GHz.
We're putting up a pair of PMP450s soon on different POPs; one will go
into a syncinjector, the other will be a CTM.
Is there some issue that you're seeing on the 3GHz varaiety?
bp
<part15sbs{at}gmail{dot}com>
On 3/2/2015 10:06 AM, George Skorup (Cyber Broadcasting) wrote:
Doesn't matter. The RJ45's are just pass-thru. The new universal
pipes pull power from two pins, so it can be used with either
PMP100/450 or 430 APs. But I always have the guys put the jumper out
to the radio into the center RJ45 and the cable from the injector to
the RJ45 with the LEDs, just as standard practice, not that it matters.
I do have a question for you about this though.. is this SyncInjector
running 3GHz 450 APs?
On 3/2/2015 11:55 AM, Bill Prince wrote:
Thanks George!
i take it from the description that this boogers up the
power/outputs such that (ether?) RJ45 on the parasitic can be used
to connect to the syncinjector? One of the RJ45s has lights, and
the other is just a vanilla shielded RJ45 (I'm looking at a rev
H1). So I can just build this little jumper for between the 6p6c
and the adjacent RJ45, then use the outer RJ45 to connect to the
syncinjector?
bp
<part15sbs{at}gmail{dot}com>
On 3/2/2015 9:44 AM, George Skorup (Cyber Broadcasting) wrote:
Yes.
http://manuals.packetflux.com/index.php?page=using-a-syncpipe-parasitic-with-a-syncinjector
On 3/2/2015 11:25 AM, Bill Prince wrote:
We have a syncpipe basic that we think is starting to act up. It
seems to lose sync about once every day or two for about 1 second.
It's starting to raise havoc with long-lasting client sessions
through the affected APs.
We only have a couple of syncpipe parasitics in stock; can one of
these be swapped in place of a basic to run a sync injector?