22-23 volts I think is the bottom of the adjustment range on the TSP
power supply. At least you know the remote cable is working because the
BCM can shut down the power supply. Try disconnecting the remote cable
and adjust the pot on the power supply up to 27.6 volts. Power off, then
reconnect the remote cable and power back up.
It was quite a while ago, but I think that's the same problem I had on
the BCM48. If the PS is turned all the way down, it sorta acts like a
limiter, so the BCM can't say "hey, I need all your volts!"
On 4/9/2015 9:29 AM, Christopher Tyler wrote:
Looks like I have a bad BCM maybe. I disconnected the battery and the temp
sensor and left the remote wire connected.
I adjusted the pot on the BCM, and it does nothing at all.
The remote wire is definitely connected correctly, if I turn off the BCM it
turns off the power supply, turn it back on, and after a few seconds it turns
the power supply back on.
