When I cut off AC power it switches over to battery just fine. It's just the power supply control that appears to be broken, everything else seems to work. I followed the instructions line for line when I got it and it didn't appear to work properly then either, so I think I just got a bad unit. Should still be under warranty so, I'll see about getting an RMA for it and thanks for the additional information, all very good information to keep in mind.
-- Christopher Tyler MTCRE/MTCNA/MTCTCE/MTCWE Total Highspeed Internet Services 417.851.1107 ----- Original Message ----- From: "Ken Hohhof" <af...@kwisp.com> To: af@afmug.com Sent: Thursday, April 9, 2015 10:25:53 AM Subject: Re: [AFMUG] Low Voltage Disconnect I'm going from memory, but I also thought they told you to adjust the pot all the way down to minimum voltage. Whatever the instructions were, I followed them and it worked. -----Original Message----- From: George Skorup (Cyber Broadcasting) Sent: Thursday, April 09, 2015 10:05 AM To: af@afmug.com Subject: Re: [AFMUG] Low Voltage Disconnect Did you reconnect the battery? It senses the battery, so it might not do anything if the battery isn't connected. With the battery connected, do you see any current going into it? Also, with the battery connected, disconnect the AC from the power supply. Do you hear the relay click in the BCM? On 4/9/2015 9:58 AM, Christopher Tyler wrote: > Just tried that and the POT still does nothing. Now it just sits at 27.6v > constantly. >