--------- but I want to make sure our ePMP APs don't clash with our APs on another tower or APs used by another operator. ---------
I am sure they will....... without GPS Sync, folks can throw up anything and cause each other grief.. with GPS sync, most likely will have negative affect to non-gps sync AP's, and that is why you need to make sure all your AP's are gps synced. Even more so in 2.4 since there isn't a whole lot of channels... Faisal Imtiaz Snappy Internet & Telecom 7266 SW 48 Street Miami, FL 33155 Tel: 305 663 5518 x 232 Help-desk: (305)663-5518 Option 2 or Email: [email protected] ----- Original Message ----- > From: "Jay Weekley" <[email protected]> > To: [email protected] > Sent: Wednesday, May 6, 2015 8:21:28 PM > Subject: Re: [AFMUG] ePMP sync > > I'll read that. It's highly unlikely that our customers will be able to > hear two of our towers under our conditions but I want to make sure our > ePMP APs don't clash with our APs on another tower or APs used by > another operator. > > Faisal Imtiaz wrote: > > Jay, > > > > There is a very nice document on channel planning on the EPMP site (same > > place where they have firmware). > > > > It discusses the different issues with sync and channel planning. > > > > The issue in your case is not so much the AP to AP potential interference > > (sync makes sure that all AP's tx at the same time, as long as the BW > > ratios are the same on the AP's). > > > > The issue will be more ..can the CPE Hear both AP's at the same time ?, > > There needs to be channel separation so that when the CPE hears AP1, it is > > not hearing AP2 on the same channel as interference.. > > > > Regards > > > > Faisal Imtiaz > > Snappy Internet & Telecom > > 7266 SW 48 Street > > Miami, FL 33155 > > Tel: 305 663 5518 x 232 > > > > Help-desk: (305)663-5518 Option 2 or Email: [email protected] > > > > ----- Original Message ----- > >> From: "Jay Weekley" <[email protected]> > >> To: "Animal Farm" <[email protected]> > >> Sent: Wednesday, May 6, 2015 6:45:25 PM > >> Subject: [AFMUG] ePMP sync > >> > >> Does channel size affect sync between towers with ePMP? For example, if > >> we have two towers with 2.4 ePMP that have line of sight to each other > >> but one is on 20 MHz wide channels and the other on 10 will they clash > >> with each other? > >> > > > >
