All of ours are synced as well as the other operator that I know of that
uses 2.4 ePMP.
Faisal Imtiaz wrote:
---------
but I want to make sure our ePMP APs don't clash with our APs on another tower
or APs used by
another operator.
---------
I am sure they will.......
without GPS Sync, folks can throw up anything and cause each other grief..
with GPS sync, most likely will have negative affect to non-gps sync AP's, and
that is why you need to make sure all your AP's are gps synced.
Even more so in 2.4 since there isn't a whole lot of channels...
Faisal Imtiaz
Snappy Internet & Telecom
7266 SW 48 Street
Miami, FL 33155
Tel: 305 663 5518 x 232
Help-desk: (305)663-5518 Option 2 or Email: [email protected]
----- Original Message -----
From: "Jay Weekley" <[email protected]>
To: [email protected]
Sent: Wednesday, May 6, 2015 8:21:28 PM
Subject: Re: [AFMUG] ePMP sync
I'll read that. It's highly unlikely that our customers will be able to
hear two of our towers under our conditions but I want to make sure our
ePMP APs don't clash with our APs on another tower or APs used by
another operator.
Faisal Imtiaz wrote:
Jay,
There is a very nice document on channel planning on the EPMP site (same
place where they have firmware).
It discusses the different issues with sync and channel planning.
The issue in your case is not so much the AP to AP potential interference
(sync makes sure that all AP's tx at the same time, as long as the BW
ratios are the same on the AP's).
The issue will be more ..can the CPE Hear both AP's at the same time ?,
There needs to be channel separation so that when the CPE hears AP1, it is
not hearing AP2 on the same channel as interference..
Regards
Faisal Imtiaz
Snappy Internet & Telecom
7266 SW 48 Street
Miami, FL 33155
Tel: 305 663 5518 x 232
Help-desk: (305)663-5518 Option 2 or Email: [email protected]
----- Original Message -----
From: "Jay Weekley" <[email protected]>
To: "Animal Farm" <[email protected]>
Sent: Wednesday, May 6, 2015 6:45:25 PM
Subject: [AFMUG] ePMP sync
Does channel size affect sync between towers with ePMP? For example, if
we have two towers with 2.4 ePMP that have line of sight to each other
but one is on 20 MHz wide channels and the other on 10 will they clash
with each other?
