for starters i would want to make sure we are not on a channel that is the same channel we are receiving from any other AP. That should allow for "clean" channels. We should only receive one channel from any "competing" channel since the other tower(s) would only have one panel facing us....
"by the book", i don't see how this is much different than 900. that being said, you may know more than i do on the situation and, as such, since i am in gulf shores and not back home where you are, i'll touch base with whatever is going on next week :) hi everyone. :) ----- Original Message ----- From: Faisal Imtiaz To: [email protected] Sent: Wednesday, May 06, 2015 7:32 PM Subject: Re: [AFMUG] ePMP sync --------- but I want to make sure our ePMP APs don't clash with our APs on another tower or APs used by another operator. --------- I am sure they will....... without GPS Sync, folks can throw up anything and cause each other grief.. with GPS sync, most likely will have negative affect to non-gps sync AP's, and that is why you need to make sure all your AP's are gps synced. Even more so in 2.4 since there isn't a whole lot of channels... Faisal Imtiaz Snappy Internet & Telecom 7266 SW 48 Street Miami, FL 33155 Tel: 305 663 5518 x 232 Help-desk: (305)663-5518 Option 2 or Email: [email protected] ----- Original Message ----- > From: "Jay Weekley" <[email protected]> > To: [email protected] > Sent: Wednesday, May 6, 2015 8:21:28 PM > Subject: Re: [AFMUG] ePMP sync > > I'll read that. It's highly unlikely that our customers will be able to > hear two of our towers under our conditions but I want to make sure our > ePMP APs don't clash with our APs on another tower or APs used by > another operator. > > Faisal Imtiaz wrote: > > Jay, > > > > There is a very nice document on channel planning on the EPMP site (same > > place where they have firmware). > > > > It discusses the different issues with sync and channel planning. > > > > The issue in your case is not so much the AP to AP potential interference > > (sync makes sure that all AP's tx at the same time, as long as the BW > > ratios are the same on the AP's). > > > > The issue will be more ..can the CPE Hear both AP's at the same time ?, > > There needs to be channel separation so that when the CPE hears AP1, it is > > not hearing AP2 on the same channel as interference.. > > > > Regards > > > > Faisal Imtiaz > > Snappy Internet & Telecom > > 7266 SW 48 Street > > Miami, FL 33155 > > Tel: 305 663 5518 x 232 > > > > Help-desk: (305)663-5518 Option 2 or Email: [email protected] > > > > ----- Original Message ----- > >> From: "Jay Weekley" <[email protected]> > >> To: "Animal Farm" <[email protected]> > >> Sent: Wednesday, May 6, 2015 6:45:25 PM > >> Subject: [AFMUG] ePMP sync > >> > >> Does channel size affect sync between towers with ePMP? For example, if > >> we have two towers with 2.4 ePMP that have line of sight to each other > >> but one is on 20 MHz wide channels and the other on 10 will they clash > >> with each other? > >> > > > >
