What radios?
On 6/9/2015 9:44 PM, Brett A Mansfield wrote:
The public is on bridge1. VLAN 100 is a layer on top of bridge1. So
public is not tagged and VLAN 100 is, both on bridge1. I have each CPE
getting an IP address on VLAN 100 and bridging the public to the
customers router.
Thank you,
Brett A Mansfield
On Jun 9, 2015, at 8:39 PM, Josh Luthman <j...@imaginenetworksllc.com
<mailto:j...@imaginenetworksllc.com>> wrote:
Is 192.168.100.1 and 108.165.x.x both on the vlan interface? Or one
bridge1 and one vlan100?
Josh Luthman
Office: 937-552-2340
Direct: 937-552-2343
1100 Wayne St
Suite 1337
Troy, OH 45373
On Tue, Jun 9, 2015 at 10:36 PM, Brett A Mansfield
<li...@silverlakeinternet.com <mailto:li...@silverlakeinternet.com>>
wrote:
The public IPs are not on a VLAN. The subnet is 108.165.x.0/24.
I currently have eth1-eth7 bridged. Bridge1 is where I have the
public IPs. Bridge1 VLAN 100 is the private IPs of
192.168.100.0/24 <http://192.168.100.0/24>. I don't use the SFP+
ports yet. Eth8 is the internet port. It has an IP address of
108.165.x.246/30. I currently have this confit on an UBNT
edgerouter and it works flawlessly other than the random panics
of the OS. The local public subnet is routed.
Thank you,
Brett A Mansfield
On Jun 9, 2015, at 8:29 PM, Josh Luthman
<j...@imaginenetworksllc.com
<mailto:j...@imaginenetworksllc.com>> wrote:
Are the public IPs on the VLAN 100 interface?
Need some configuration here. What are the device's
IPs/subnets? What is the Mikrotik's LAN/vlan100 IP/subnet?
What about WAN? Is the local "LAN" public subnet routed to the
rest of the world?
Josh Luthman
Office: 937-552-2340 <tel:937-552-2340>
Direct: 937-552-2343 <tel:937-552-2343>
1100 Wayne St
Suite 1337
Troy, OH 45373
On Tue, Jun 9, 2015 at 10:27 PM, Brett A Mansfield
<li...@silverlakeinternet.com
<mailto:li...@silverlakeinternet.com>> wrote:
I am fairly new to Mikrotik and I cannot get it to do what I
want. I have the CCR1036-8G-2S+. I have one VLAN using
private IPs. It’s VLAN 100. I also have a /24 subnet of
public IPs. I have NAT setup for the VLAN because it does
need internet access. I have no NAT on the untagged VLAN of
public IPs. I can access the net using VLAN 100, but not
the public IPs. Anyone else run into this or have any ideas
or thoughts?
I’ve tried both Static and Dynamic IPs. I have NOT tried to
removing the VLAN 100 yet. I will give that a shot later
today. I do not have any kind of firewall on here just yet.
Thank you,
Brett A Mansfield
Silver Lake Internet, LLC
