I am not using PPPoE. The subscriber radios will connect to the access
point and pull down their wireless uplink and downlink numbers. They
will stay connected to the access point for about 1 minute 10 seconds
and then they will drop off. A minute later, it will reconnect and
follow the 1 minute cycle. This only happens when I change the software
on the access point. When I reboot the subscriber stations after
upgrading the access point, the subscribers will stay registered to the
access point, but not until I have rebooted the subscriber modules.
Gilbert
On 2/12/2016 10:20 AM, Josh Luthman wrote:
I haven't had any problems between 2.4.3 and 2.6 as far as *wireless*
registration association. Since you're specifying you use radius, are
you talking about the PPPOE session?
Josh Luthman
Office: 937-552-2340
Direct: 937-552-2343
1100 Wayne St
Suite 1337
Troy, OH 45373
On Fri, Feb 12, 2016 at 12:18 PM, Gilbert T. Gutierrez, Jr.
<[email protected] <mailto:[email protected]>>
wrote:
I have an issue that some of you may have experienced and I was
hoping there was a work around.
1. I use radius
2. All subscriber stations are now running 2.6
3. All access points are running 2.4.3
The issue is that when I update the firmware on the Access Points,
the subscriber modules will not hold registration. This activity
will continue even after I downgrade back to 2.4.3 on the access
points. The registration maxes out just over one minute per
subscriber. If I soft or hard reboot the subscriber stations, they
will then again hold their registration.
Is there a work around for this? I am assuming this is an issue
with the 2.6 software on the subscribers. Has anyone else
experienced this same issue?
Gilbert
