I am using GPS and I am not seeing any events in the log to indicate DFS
or self interference.
Gilbert
On 2/12/2016 10:33 AM, Josh Luthman wrote:
Does 2.4.3 allow to society cmm3 or cmm4? What are you using for
sync? Any chance it's a self interference issue that expects the
right CMM type?
Josh Luthman
Office: 937-552-2340
Direct: 937-552-2343
1100 Wayne St
Suite 1337
Troy, OH 45373
On Feb 12, 2016 12:25 PM, "Gilbert T. Gutierrez, Jr."
<[email protected] <mailto:[email protected]>>
wrote:
I am not using PPPoE. The subscriber radios will connect to the
access point and pull down their wireless uplink and downlink
numbers. They will stay connected to the access point for about 1
minute 10 seconds and then they will drop off. A minute later, it
will reconnect and follow the 1 minute cycle. This only happens
when I change the software on the access point. When I reboot the
subscriber stations after upgrading the access point, the
subscribers will stay registered to the access point, but not
until I have rebooted the subscriber modules.
Gilbert
On 2/12/2016 10:20 AM, Josh Luthman wrote:
I haven't had any problems between 2.4.3 and 2.6 as far as
*wireless* registration association. Since you're specifying you
use radius, are you talking about the PPPOE session?
Josh Luthman
Office: 937-552-2340 <tel:937-552-2340>
Direct: 937-552-2343 <tel:937-552-2343>
1100 Wayne St
Suite 1337
Troy, OH 45373
On Fri, Feb 12, 2016 at 12:18 PM, Gilbert T. Gutierrez, Jr.
<[email protected]
<mailto:[email protected]>> wrote:
I have an issue that some of you may have experienced and I
was hoping there was a work around.
1. I use radius
2. All subscriber stations are now running 2.6
3. All access points are running 2.4.3
The issue is that when I update the firmware on the Access
Points, the subscriber modules will not hold registration.
This activity will continue even after I downgrade back to
2.4.3 on the access points. The registration maxes out just
over one minute per subscriber. If I soft or hard reboot the
subscriber stations, they will then again hold their
registration.
Is there a work around for this? I am assuming this is an
issue with the 2.6 software on the subscribers. Has anyone
else experienced this same issue?
Gilbert
