Thank you for your update. At least I am not the only one to see this
issue. Most of my towers are 450 radios so I have little experience with
the ePMP with the exception of a small tower with about 50 subscribers.
Those radios have worked well for me with the 2.4.3 release. I am though
deploying on a new set of towers and was testing the 2.6 release. My
very limited tests worked fine so I decided to upgrade the small tower
to 2.6. That is when I began having this issue. I am almost certain the
issue is on the subscriber side since it is not dependent on the access
point software release with my limited experience.
Gilbert
On 2/12/2016 10:27 AM, Sovereen, David A wrote:
There are known issues that have been resolved and still what appear
to be unknown issues that are not understood or resolved. We are
actively working with Cambium on it. We have 2.6.1RC8, which fixes
the known issues, but we are still having issues, which they are
actively investigating.
The issues are RADIUS-specific. We changed one AP and all SMs to Open
and the sessions stayed up, but going back to RADIUS causes sessions
to drop again.
Dave
On Feb 12, 2016, at 12:20 PM, Josh Luthman
<[email protected] <mailto:[email protected]>> wrote:
I haven't had any problems between 2.4.3 and 2.6 as far as *wireless*
registration association. Since you're specifying you use radius,
are you talking about the PPPOE session?
Josh Luthman
Office: 937-552-2340
Direct: 937-552-2343
1100 Wayne St
Suite 1337
Troy, OH 45373
On Fri, Feb 12, 2016 at 12:18 PM, Gilbert T. Gutierrez, Jr.
<[email protected]
<mailto:[email protected]>> wrote:
I have an issue that some of you may have experienced and I was
hoping there was a work around.
1. I use radius
2. All subscriber stations are now running 2.6
3. All access points are running 2.4.3
The issue is that when I update the firmware on the Access
Points, the subscriber modules will not hold registration. This
activity will continue even after I downgrade back to 2.4.3 on
the access points. The registration maxes out just over one
minute per subscriber. If I soft or hard reboot the subscriber
stations, they will then again hold their registration.
Is there a work around for this? I am assuming this is an issue
with the 2.6 software on the subscribers. Has anyone else
experienced this same issue?
Gilbert
