Does 2.4.3 allow to society cmm3 or cmm4? What are you using for sync? Any chance it's a self interference issue that expects the right CMM type?
Josh Luthman Office: 937-552-2340 Direct: 937-552-2343 1100 Wayne St Suite 1337 Troy, OH 45373 On Feb 12, 2016 12:25 PM, "Gilbert T. Gutierrez, Jr." < [email protected]> wrote: > I am not using PPPoE. The subscriber radios will connect to the access > point and pull down their wireless uplink and downlink numbers. They will > stay connected to the access point for about 1 minute 10 seconds and then > they will drop off. A minute later, it will reconnect and follow the 1 > minute cycle. This only happens when I change the software on the access > point. When I reboot the subscriber stations after upgrading the access > point, the subscribers will stay registered to the access point, but not > until I have rebooted the subscriber modules. > > Gilbert > > On 2/12/2016 10:20 AM, Josh Luthman wrote: > > I haven't had any problems between 2.4.3 and 2.6 as far as *wireless* > registration association. Since you're specifying you use radius, are you > talking about the PPPOE session? > > > Josh Luthman > Office: 937-552-2340 > Direct: 937-552-2343 > 1100 Wayne St > Suite 1337 > Troy, OH 45373 > > On Fri, Feb 12, 2016 at 12:18 PM, Gilbert T. Gutierrez, Jr. < > [email protected]> wrote: > >> I have an issue that some of you may have experienced and I was hoping >> there was a work around. >> >> 1. I use radius >> 2. All subscriber stations are now running 2.6 >> 3. All access points are running 2.4.3 >> >> The issue is that when I update the firmware on the Access Points, the >> subscriber modules will not hold registration. This activity will continue >> even after I downgrade back to 2.4.3 on the access points. The registration >> maxes out just over one minute per subscriber. If I soft or hard reboot the >> subscriber stations, they will then again hold their registration. >> >> Is there a work around for this? I am assuming this is an issue with the >> 2.6 software on the subscribers. Has anyone else experienced this same >> issue? >> >> Gilbert >> > > >
