So you went back to UBNT in 2.4? From: Af [mailto:[email protected]] On Behalf Of Josh Luthman Sent: Sunday, June 5, 2016 9:57 PM To: [email protected] Subject: Re: [AFMUG] PMP450 vs. ePMP
No. I have no pmp450 in my network simply due to cost. Josh Luthman Office: 937-552-2340 Direct: 937-552-2343 1100 Wayne St Suite 1337 Troy, OH 45373 On Sun, Jun 5, 2016 at 9:48 PM, Paul McCall <[email protected]<mailto:[email protected]>> wrote: Josh, Have you tried 450 2.4 in the exact situation where ePMP 2.4 “sucked”? From: Af [mailto:[email protected]<mailto:[email protected]>] On Behalf Of Josh Luthman Sent: Thursday, June 2, 2016 5:10 PM To: [email protected]<mailto:[email protected]> Subject: Re: [AFMUG] PMP450 vs. ePMP No...it's not. The EPMP 2.4 radios just suck at penetration. I've done Ubnt KPP and IT Elite - they all performed terribly. Josh Luthman Office: 937-552-2340<tel:937-552-2340> Direct: 937-552-2343<tel:937-552-2343> 1100 Wayne St Suite 1337 Troy, OH 45373 On Thu, Jun 2, 2016 at 4:59 PM, CBB - Jay Fuller <[email protected]<mailto:[email protected]>> wrote: hmm, i will check into that. Pretty sure with ubnt we're using kp performance. With epmp, i think it is bundled antennas... ----- Original Message ----- From: Ken Hohhof<mailto:[email protected]> To: [email protected]<mailto:[email protected]> Sent: Thursday, June 02, 2016 3:50 PM Subject: Re: [AFMUG] PMP450 vs. ePMP Jay, I suspect the difference you are seeing may be mainly in the antennas. 2.4 GHz from any vendor should penetrate the same, the radio waves don’t care what brand radio launched them. And I think the difference between the platforms will be most evident in low interference environment where they can achieve their full modulation and throughput. With low SNR, I think it’s kind of like arguing Ferrari vs Porsche for off road racing, neither will be able to show off its capabilities. Receiver sensitivity and bits/sec/Hz won’t matter. From: CBB - Jay Fuller<mailto:[email protected]> Sent: Thursday, June 02, 2016 3:28 PM To: [email protected]<mailto:[email protected]> Subject: Re: [AFMUG] PMP450 vs. ePMP Also interested in interference rejection of the pmp450 - is there any (in 2.4) we are getting better foliage penetration with ubnt 2.4 than epmp 2.4 - - and from the performance of the epmp 2.4 i wish wish wish it penetrated better! ----- Original Message ----- From: Matt<mailto:[email protected]> To: [email protected]<mailto:[email protected]> Sent: Thursday, June 02, 2016 2:25 PM Subject: [AFMUG] PMP450 vs. ePMP We have mostly PMP100 and PMP450 deployed. Some Ubiquiti we tried and some we inherited as well. Have some ePMP we have tested but so far have not deployed more then couple test links. For those who have tried both ePMP and PMP450 what are the differences you have seen in performance? Interference tolerance among others? For those that have gone with PMP450 over ePMP what was the reasoning?
