Used lots of ‘em. They were made not too far from where I sit today. From: Dustin Jurman Sent: Tuesday, May 23, 2017 8:31 AM To: [email protected] Subject: Re: [AFMUG] Ethernet over coax
Better hit the mark on that thicknet with a Vampire Tap or you’ll get some reflections. Since you said Vampire Tap I’m going to counter with NE2000. DSJ From: Af [mailto:[email protected]] On Behalf Of Chuck McCown Sent: Tuesday, May 23, 2017 10:22 AM To: [email protected] Subject: Re: [AFMUG] Ethernet over coax Vampire tap. From: Dustin Jurman Sent: Tuesday, May 23, 2017 8:21 AM To: [email protected] Subject: Re: [AFMUG] Ethernet over coax Those were the good old days when the only tools you needed was a t connector and a 50 ohm terminator. J DSJ From: Af [mailto:[email protected]] On Behalf Of Ron M. Sent: Tuesday, May 23, 2017 10:11 AM To: [email protected] Subject: Re: [AFMUG] Ethernet over coax https://en.wikipedia.org/wiki/10BASE2 Been there, done that? On Mon, May 22, 2017 at 3:42 PM, Harold Bledsoe <[email protected]> wrote: Hi folks, It's that time again - looking for brave, er I mean beta users for an ethernet over coax system. The same one could be used for phone line later. The protocol is based on g.hn so it can support PTMP on the system. Please shoot me a note offlist and I'll get you added. Thanks, -Hal
