FINE! – Thomas Conrad 100mb arcnet. Mike Drop….. From: Af [mailto:[email protected]] On Behalf Of Jaime Solorza Sent: Tuesday, May 23, 2017 10:42 AM To: Animal Farm <[email protected]> Subject: Re: [AFMUG] Ethernet over coax
IBM 5250 emulation Novell cards in IBM XT PC over WaveLAN 900 MHz link for Cal TV...3 miles .. July 1992... On May 23, 2017 8:31 AM, "Dustin Jurman" <[email protected]<mailto:[email protected]>> wrote: Better hit the mark on that thicknet with a Vampire Tap or you’ll get some reflections. Since you said Vampire Tap I’m going to counter with NE2000. DSJ From: Af [mailto:[email protected]<mailto:[email protected]>] On Behalf Of Chuck McCown Sent: Tuesday, May 23, 2017 10:22 AM To: [email protected]<mailto:[email protected]> Subject: Re: [AFMUG] Ethernet over coax Vampire tap. From: Dustin Jurman Sent: Tuesday, May 23, 2017 8:21 AM To: [email protected]<mailto:[email protected]> Subject: Re: [AFMUG] Ethernet over coax Those were the good old days when the only tools you needed was a t connector and a 50 ohm terminator. ☺ DSJ From: Af [mailto:[email protected]] On Behalf Of Ron M. Sent: Tuesday, May 23, 2017 10:11 AM To: [email protected]<mailto:[email protected]> Subject: Re: [AFMUG] Ethernet over coax https://en.wikipedia.org/wiki/10BASE2 Been there, done that? On Mon, May 22, 2017 at 3:42 PM, Harold Bledsoe <[email protected]<mailto:[email protected]>> wrote: Hi folks, It's that time again - looking for brave, er I mean beta users for an ethernet over coax system. The same one could be used for phone line later. The protocol is based on g.hn<http://g.hn> so it can support PTMP on the system. Please shoot me a note offlist and I'll get you added. Thanks, -Hal
