Was that to more than one computer? Was it even called a computer then? Abacus?

On 05/23/2017 07:54 AM, Chuck McCown wrote:
JC Penny protocol over Bell 202 4 wire circuits.  1978

-----Original Message----- From: Robert
Sent: Tuesday, May 23, 2017 8:52 AM
To: [email protected]
Subject: Re: [AFMUG] Ethernet over coax

PrimeOS networking, write your own damn drivers...  In Pascal! 1982

On 5/23/17 7:48 AM, Dustin Jurman wrote:
FINE! – Thomas Conrad 100mb arcnet.  Mike Drop…..

*From:* Af [mailto:[email protected]] *On Behalf Of *Jaime Solorza
*Sent:* Tuesday, May 23, 2017 10:42 AM
*To:* Animal Farm <[email protected]>
*Subject:* Re: [AFMUG] Ethernet over coax

IBM 5250 emulation Novell cards in IBM XT PC over WaveLAN 900 MHz link
for Cal TV...3 miles .. July 1992...

On May 23, 2017 8:31 AM, "Dustin Jurman" <[email protected]
<mailto:[email protected]>> wrote:

    Better hit the mark on that thicknet with a Vampire Tap or you’ll
    get some reflections.  Since you said Vampire Tap I’m going to
    counter with NE2000.

    DSJ

    *From:* Af [mailto:[email protected]
    <mailto:[email protected]>] *On Behalf Of *Chuck McCown
    *Sent:* Tuesday, May 23, 2017 10:22 AM
    *To:* [email protected] <mailto:[email protected]>
    *Subject:* Re: [AFMUG] Ethernet over coax

    Vampire tap.

    *From:*Dustin Jurman

    *Sent:*Tuesday, May 23, 2017 8:21 AM

    *To:*[email protected] <mailto:[email protected]>

    *Subject:*Re: [AFMUG] Ethernet over coax

    Those were the good old days when the only tools you needed was a t
    connector and a 50 ohm terminator. J

    DSJ

    *From:*Af [mailto:[email protected]] *On Behalf Of *Ron M.
    *Sent:* Tuesday, May 23, 2017 10:11 AM
    *To:* [email protected] <mailto:[email protected]>
    *Subject:* Re: [AFMUG] Ethernet over coax

    https://en.wikipedia.org/wiki/10BASE2

    Been there, done that?

    On Mon, May 22, 2017 at 3:42 PM, Harold Bledsoe
    <[email protected] <mailto:[email protected]>> wrote:

        Hi folks,

        It's that time again - looking for brave, er I mean beta users
        for an ethernet over coax system.  The same one could be used
        for phone line later.

        The protocol is based on g.hn <http://g.hn> so it can support
        PTMP on the system.

        Please shoot me a note offlist and I'll get you added.

        Thanks,

        -Hal


Reply via email to