Smoke signals from Chaco Canyon ...zaz On May 23, 2017 8:54 AM, "Chuck McCown" <[email protected]> wrote:
JC Penny protocol over Bell 202 4 wire circuits. 1978 -----Original Message----- From: Robert Sent: Tuesday, May 23, 2017 8:52 AM To: [email protected] Subject: Re: [AFMUG] Ethernet over coax PrimeOS networking, write your own damn drivers... In Pascal! 1982 On 5/23/17 7:48 AM, Dustin Jurman wrote: > FINE! – Thomas Conrad 100mb arcnet. Mike Drop….. > > *From:* Af [mailto:[email protected]] *On Behalf Of *Jaime Solorza > *Sent:* Tuesday, May 23, 2017 10:42 AM > *To:* Animal Farm <[email protected]> > *Subject:* Re: [AFMUG] Ethernet over coax > > IBM 5250 emulation Novell cards in IBM XT PC over WaveLAN 900 MHz link for > Cal TV...3 miles .. July 1992... > > On May 23, 2017 8:31 AM, "Dustin Jurman" <[email protected] <mailto: > [email protected]>> wrote: > > Better hit the mark on that thicknet with a Vampire Tap or you’ll > get some reflections. Since you said Vampire Tap I’m going to > counter with NE2000. > > DSJ > > *From:* Af [mailto:[email protected] > <mailto:[email protected]>] *On Behalf Of *Chuck McCown > *Sent:* Tuesday, May 23, 2017 10:22 AM > *To:* [email protected] <mailto:[email protected]> > *Subject:* Re: [AFMUG] Ethernet over coax > > Vampire tap. > > *From:*Dustin Jurman > > *Sent:*Tuesday, May 23, 2017 8:21 AM > > *To:*[email protected] <mailto:[email protected]> > > *Subject:*Re: [AFMUG] Ethernet over coax > > > Those were the good old days when the only tools you needed was a t > connector and a 50 ohm terminator. J > > DSJ > > *From:*Af [mailto:[email protected]] *On Behalf Of *Ron M. > *Sent:* Tuesday, May 23, 2017 10:11 AM > > *To:* [email protected] <mailto:[email protected]> > *Subject:* Re: [AFMUG] Ethernet over coax > > > https://en.wikipedia.org/wiki/10BASE2 > > Been there, done that? > > On Mon, May 22, 2017 at 3:42 PM, Harold Bledsoe > <[email protected] <mailto:[email protected]>> wrote: > > Hi folks, > > It's that time again - looking for brave, er I mean beta users > for an ethernet over coax system. The same one could be used > for phone line later. > > The protocol is based on g.hn <http://g.hn> so it can support > > PTMP on the system. > > Please shoot me a note offlist and I'll get you added. > > Thanks, > > -Hal > >
