At Thu, 13 Jun 2002 01:48:33 +0900, Patrick Shirkey wrote: > > Patrick Shirkey wrote: > > Patrick Shirkey wrote: > > > >> > >> i have been testing the sound and I am getting playback although at > >> this point I can get sound out of hw:2,0 and hw:2,2 they are both the > >> left channels. The sound is scratchy but it is there :) > >> > > > > The sound is actually coming through output 2 and 4 on the sound card > > even though I'm using hw:2,0 or hw:2,2. > > > > When I use the first two pcm devices the sound is sent through output 2 > on the card and when I use the third the sound is sent through output 4.
i committed a minor change to cvs. now endpoints will be shown in each proc file. could you apply and send me the output of each proc file? i'd like to know whether really endpoints are parsed correctly. > I have also tested capture and the card is not working with that yet. > > It will attempt to record for a few seconds but will not write to a file > or produce any noise either with direct monitoring enabled or not. Also > recording locks the mouse until either it has finished or is ctrl+c'd. hmm, this sounds bad. i'm not sure whether this is a general capture problem on usb audio. i'll borrow a usb mic tomorrow and test with it. ciao, Takashi _______________________________________________________________ Sponsored by: ThinkGeek at http://www.ThinkGeek.com/ _______________________________________________ Alsa-devel mailing list [EMAIL PROTECTED] https://lists.sourceforge.net/lists/listinfo/alsa-devel
