I tried turning on terminal window (Autologin off) but it didn't work,
however when I did turn it on and tried to connect I could enter my login
name but not my password, the cursor wouldn't even move, I called my ISP and
they told me that when I enter my password *'s should appear, I tried typing
any key and nothing would appear, so I'm not sure what is up, anyways if you
can help me anymore I'd appreciate it.
Thanks so much
Curtis Matthiesen
----- Original Message -----
From: "Clarence Verge" <[EMAIL PROTECTED]>
To: <[EMAIL PROTECTED]>
Sent: Wednesday, December 13, 2000 7:08 AM
Subject: Re: PPP Link Is Down, Driver Not Installed???
> On Tue, 12 Dec 2000 21:48:44 -0000, Curtis Matthiesen wrote:
>
> > for your information I'm using automatic login and I'm using version
1.68
> > and yes I've got two Nameserver numbers in my Arachne.cfg and my PPP.log
and
> > Arachne.cfg are as follows:
>
> > -snip-
> > Autologin No
>
> > -snip-
> > PPPusername [EMAIL PROTECTED]
> > PPPpassword XXXXXXX
>
> > -snip-
> > IP_Grab IP address set to
>
> > PPP.log is below, and I got this after I got disconnected and got the
> > error message:
>
> > -snip-
> > * Leaving MINITERM and trying SLIP/PPP. Press <Ctrl>+<Pause> to abort.
> > PPPD status: IP address set to
>
> Hi Curtis;
> From the above it seems that with Autologin No the script you filled
> out will not be followed, (that's ok) but login is expected to take
> place inside the PPP session (CHAP I think).
> So you got as far as attempting to load the PPP driver.
>
> Up to this point it is fine *IF* that is what you intended to do.
> It seems a bit strange to fill in the script and not use it - BUT
> that is EXACTLY the way mine is because I had previously used a
> script with Autologin Yes and my ISP switched to PPP login so I
> just set Autologin to No and left the script.
>
> If you DO want to follow the script for prompts and replies, you
> must set Autologin Yes.
>
> If the problem is failure of the PPP login authentication, you might
> want to check your password. Otherwise, I'm at a loss because it all
> looks fine for the PPP type login. :(
>
>
>
>
>
>
> - Clarence Verge
> - Still using Arachne V1.62 ....
>
