Hi,
That's true. What you would need is a tftp server on the data side
that would provide just the aastra.cfg with the proper vlan
configuration and devide a way to have the phone reboot after it has
fetched this new configuration. This could be done by having a different
firmware version on the data vlan tftp server that on the voice tftp
server vlan.
So when you power up a new/unconfigured phone it will:
1. Get the aastra.cfg from the data vlan tftp
2. Get the (older) firmware from the data vlan tftp
3. Reboot at this point it should have the voice vlan config
4. Get the aastra.cfg and mac.cfg from the voice vlan tftp
5. Get the (new) firmware from the voice vlan tftp
6. Reboot and should now be functional
I have not tried that (don't have a managed switch lying around...)
but I believe it could work...
----
Andre Courchesne - Consultant
http://www.net-forces.com
Phone: (514) 667-8448
MSN: [email protected]
Skype: VoipForces
L'information contenue dans le présent document est la propriété de
Andre Courchesne. Et est divulguée en toute confidentialité. Cette
information ne doit pas être utilisée, divulguée à d'autres personnes ou
reproduite sans le consentement écrit explicite de Andre Courchesne.
The information contained in this document is confidential and property
of Andre Courchesne. It shall not be used, disclosed to others or
reproduced without the express written consent of Andre Courchesne.
Bruce zhang wrote:
Hello Andre,
Actually, I configured tftp also, because the tftp is in voice vlan,
but after the switch reboot, the manually configured vlan information
on the phone is also lost. Then the phone got the data vlan ip
address. I have to reconfigure the phone manually again.
But the 9133i phone is ok. only 480i has this problem.
Bruce
On Fri, Jan 16, 2009 at 9:43 PM, Andre Courchesne - Consultant
<[email protected]> wrote:
Hi,
Yes I have seen that with Linksys switches. If the power fluctuates
(on-off-on-off) at some point in the reboot process it might cause that.
This is why I now install mDNS and DHCP so that the phone self configures
using the tftp configuration.
----
Andre Courchesne - Consultant
http://www.net-forces.com
Phone: (514) 667-8448
MSN: [email protected]
Skype: VoipForces
L'information contenue dans le présent document est la propriété de Andre
Courchesne. Et est divulguée en toute confidentialité. Cette information ne
doit pas être utilisée, divulguée à d'autres personnes ou reproduite sans le
consentement écrit explicite de Andre Courchesne.
The information contained in this document is confidential and property of
Andre Courchesne. It shall not be used, disclosed to others or reproduced
without the express written consent of Andre Courchesne.
Bruce Zhang wrote:
Hello all,
My 480i and 9332i phones connect to Linksys switch and get power through
POE. And manually configure it to vlan 100 and the pass through port to be
vlan 1.
After I reboot the switch, 480i lost all the configuration even the vlan
config.
But the 9332i phone is still alive, and connect to server ok.
Did you guys have this situation before?
Regards,
Bruce Zhang
[email protected]
(416)834-5988
---------------------------------------------------------------------
To unsubscribe, e-mail: [email protected]
For additional commands, e-mail: [email protected]
