Thanks for the info. Yes, I do get that, meaning the call does hang up 10-11 seconds after the remote party hangs up. This also means Asterisk voicemail gives me 10 second blank messages if the call had ended up in voicemail.
Any way around that? -- Nabeel Jafferali X2 Networks -----Original Message----- From: Jim Van Meggelen [mailto:[email protected]] Sent: February-09-09 5:53 PM To: Nabeel Jafferali Cc: [email protected] Subject: Re: [on-asterisk] Audiocodes - Disconnect Supervision You have to wait for the far-end disconnect from the carrier. If you have a butt set you can monitor the line and listen for it. I have found it usually takes about 11 seconds to get the signal. Nabeel Jafferali wrote: > I have an Audiocodes MP-118FXO in production. When a call is made and the > remote party hangs up, the Audiocodes hangs up the call immediately. But if a > call is received and the remote party hangs up, the Audiocodes does not hang > up immediately. > > Anyone experienced this issue with Audiocodes or any other gateway in > general? Any tips? > > -- > Nabeel Jafferali > X2 Networks > > > -- -- Jim Van Meggelen [email protected] http://www.oreillynet.com/pub/au/2177 "A child is the ultimate startup, and I have three. This makes me rich." Guy Kawasaki -- --------------------------------------------------------------------- To unsubscribe, e-mail: [email protected] For additional commands, e-mail: [email protected] --------------------------------------------------------------------- To unsubscribe, e-mail: [email protected] For additional commands, e-mail: [email protected]
