Ummm, I don't think that would work. If I set minmessage=3 and maxsilence=2, it would hang up when somebody paused normally in a voicemail, right?
-- Nabeel Jafferali X2 Networks -----Original Message----- From: Philip Mullis [mailto:[email protected]] Sent: February-09-09 6:08 PM To: Nabeel Jafferali Cc: Jim Van Meggelen; [email protected] Subject: Re: [on-asterisk] Audiocodes - Disconnect Supervision you said you get a good 10 seconds of dead air in voicemail? with that bagage of time you should be able to trim that right up ;) Nabeel Jafferali wrote: > Yes, but an unreasonably low minmessage would also eliminate the quick "hey > mike, call me" voicemails. > > -- > Nabeel Jafferali > X2 Networks > > > -----Original Message----- > From: Philip Mullis [mailto:[email protected]] > Sent: February-09-09 6:05 PM > To: Nabeel Jafferali > Cc: Jim Van Meggelen; [email protected] > Subject: Re: [on-asterisk] Audiocodes - Disconnect Supervision > > in the voicemail.conf you can try setting the silencethreshold, > maxsilence variables > to indicate a cut off lower than that of the required minimum vm length, > this might get you around phantom voicemails left this way. > > > Nabeel Jafferali wrote: > >> Thanks for the info. >> >> Yes, I do get that, meaning the call does hang up 10-11 seconds after the >> remote party hangs up. This also means Asterisk voicemail gives me 10 second >> blank messages if the call had ended up in voicemail. >> >> Any way around that? >> >> -- >> Nabeel Jafferali >> X2 Networks >> >> >> -----Original Message----- >> From: Jim Van Meggelen [mailto:[email protected]] >> Sent: February-09-09 5:53 PM >> To: Nabeel Jafferali >> Cc: [email protected] >> Subject: Re: [on-asterisk] Audiocodes - Disconnect Supervision >> >> You have to wait for the far-end disconnect from the carrier. If you >> have a butt set you can monitor the line and listen for it. I have found >> it usually takes about 11 seconds to get the signal. >> >> Nabeel Jafferali wrote: >> >> >>> I have an Audiocodes MP-118FXO in production. When a call is made and the >>> remote party hangs up, the Audiocodes hangs up the call immediately. But if >>> a call is received and the remote party hangs up, the Audiocodes does not >>> hang up immediately. >>> >>> Anyone experienced this issue with Audiocodes or any other gateway in >>> general? Any tips? >>> >>> -- >>> Nabeel Jafferali >>> X2 Networks >>> >>> >>> >>> >>> >> >> > > > --------------------------------------------------------------------- > To unsubscribe, e-mail: [email protected] > For additional commands, e-mail: [email protected] > > > --------------------------------------------------------------------- > To unsubscribe, e-mail: [email protected] > For additional commands, e-mail: [email protected] > > --------------------------------------------------------------------- To unsubscribe, e-mail: [email protected] For additional commands, e-mail: [email protected] --------------------------------------------------------------------- To unsubscribe, e-mail: [email protected] For additional commands, e-mail: [email protected]
