you also have silencethreshold, if you have dead air youll have no audio
comming on one side hopefully whereas if you have someone on the line
there is always a bit of noise.
Nabeel Jafferali wrote:
Ummm, I don't think that would work. If I set minmessage=3 and maxsilence=2, it
would hang up when somebody paused normally in a voicemail, right?
--
Nabeel Jafferali
X2 Networks
-----Original Message-----
From: Philip Mullis [mailto:[email protected]]
Sent: February-09-09 6:08 PM
To: Nabeel Jafferali
Cc: Jim Van Meggelen; [email protected]
Subject: Re: [on-asterisk] Audiocodes - Disconnect Supervision
you said you get a good 10 seconds of dead air in voicemail? with that
bagage of time you should be able to trim that right up ;)
Nabeel Jafferali wrote:
Yes, but an unreasonably low minmessage would also eliminate the quick "hey mike,
call me" voicemails.
--
Nabeel Jafferali
X2 Networks
-----Original Message-----
From: Philip Mullis [mailto:[email protected]]
Sent: February-09-09 6:05 PM
To: Nabeel Jafferali
Cc: Jim Van Meggelen; [email protected]
Subject: Re: [on-asterisk] Audiocodes - Disconnect Supervision
in the voicemail.conf you can try setting the silencethreshold,
maxsilence variables
to indicate a cut off lower than that of the required minimum vm length,
this might get you around phantom voicemails left this way.
Nabeel Jafferali wrote:
Thanks for the info.
Yes, I do get that, meaning the call does hang up 10-11 seconds after the
remote party hangs up. This also means Asterisk voicemail gives me 10 second
blank messages if the call had ended up in voicemail.
Any way around that?
--
Nabeel Jafferali
X2 Networks
-----Original Message-----
From: Jim Van Meggelen [mailto:[email protected]]
Sent: February-09-09 5:53 PM
To: Nabeel Jafferali
Cc: [email protected]
Subject: Re: [on-asterisk] Audiocodes - Disconnect Supervision
You have to wait for the far-end disconnect from the carrier. If you
have a butt set you can monitor the line and listen for it. I have found
it usually takes about 11 seconds to get the signal.
Nabeel Jafferali wrote:
I have an Audiocodes MP-118FXO in production. When a call is made and the
remote party hangs up, the Audiocodes hangs up the call immediately. But if a
call is received and the remote party hangs up, the Audiocodes does not hang up
immediately.
Anyone experienced this issue with Audiocodes or any other gateway in general?
Any tips?
--
Nabeel Jafferali
X2 Networks
---------------------------------------------------------------------
To unsubscribe, e-mail: [email protected]
For additional commands, e-mail: [email protected]
---------------------------------------------------------------------
To unsubscribe, e-mail: [email protected]
For additional commands, e-mail: [email protected]
---------------------------------------------------------------------
To unsubscribe, e-mail: [email protected]
For additional commands, e-mail: [email protected]
---------------------------------------------------------------------
To unsubscribe, e-mail: [email protected]
For additional commands, e-mail: [email protected]
