Yes, but an unreasonably low minmessage would also eliminate the quick "hey mike, call me" voicemails.
-- Nabeel Jafferali X2 Networks -----Original Message----- From: Philip Mullis [mailto:[email protected]] Sent: February-09-09 6:05 PM To: Nabeel Jafferali Cc: Jim Van Meggelen; [email protected] Subject: Re: [on-asterisk] Audiocodes - Disconnect Supervision in the voicemail.conf you can try setting the silencethreshold, maxsilence variables to indicate a cut off lower than that of the required minimum vm length, this might get you around phantom voicemails left this way. Nabeel Jafferali wrote: > Thanks for the info. > > Yes, I do get that, meaning the call does hang up 10-11 seconds after the > remote party hangs up. This also means Asterisk voicemail gives me 10 second > blank messages if the call had ended up in voicemail. > > Any way around that? > > -- > Nabeel Jafferali > X2 Networks > > > -----Original Message----- > From: Jim Van Meggelen [mailto:[email protected]] > Sent: February-09-09 5:53 PM > To: Nabeel Jafferali > Cc: [email protected] > Subject: Re: [on-asterisk] Audiocodes - Disconnect Supervision > > You have to wait for the far-end disconnect from the carrier. If you > have a butt set you can monitor the line and listen for it. I have found > it usually takes about 11 seconds to get the signal. > > Nabeel Jafferali wrote: > >> I have an Audiocodes MP-118FXO in production. When a call is made and the >> remote party hangs up, the Audiocodes hangs up the call immediately. But if >> a call is received and the remote party hangs up, the Audiocodes does not >> hang up immediately. >> >> Anyone experienced this issue with Audiocodes or any other gateway in >> general? Any tips? >> >> -- >> Nabeel Jafferali >> X2 Networks >> >> >> >> > > > --------------------------------------------------------------------- To unsubscribe, e-mail: [email protected] For additional commands, e-mail: [email protected] --------------------------------------------------------------------- To unsubscribe, e-mail: [email protected] For additional commands, e-mail: [email protected]
