you said you get a good 10 seconds of dead air in voicemail? with that bagage of time you should be able to trim that right up ;)

Nabeel Jafferali wrote:
Yes, but an unreasonably low minmessage would also eliminate the quick "hey mike, 
call me" voicemails.

--
Nabeel Jafferali
X2 Networks


-----Original Message-----
From: Philip Mullis [mailto:[email protected]] Sent: February-09-09 6:05 PM
To: Nabeel Jafferali
Cc: Jim Van Meggelen; [email protected]
Subject: Re: [on-asterisk] Audiocodes - Disconnect Supervision

in the voicemail.conf you can try setting the silencethreshold, maxsilence variables to indicate a cut off lower than that of the required minimum vm length, this might get you around phantom voicemails left this way.


Nabeel Jafferali wrote:
Thanks for the info.

Yes, I do get that, meaning the call does hang up 10-11 seconds after the 
remote party hangs up. This also means Asterisk voicemail gives me 10 second 
blank messages if the call had ended up in voicemail.

Any way around that?

--
Nabeel Jafferali
X2 Networks


-----Original Message-----
From: Jim Van Meggelen [mailto:[email protected]] Sent: February-09-09 5:53 PM
To: Nabeel Jafferali
Cc: [email protected]
Subject: Re: [on-asterisk] Audiocodes - Disconnect Supervision

You have to wait for the far-end disconnect from the carrier. If you have a butt set you can monitor the line and listen for it. I have found it usually takes about 11 seconds to get the signal.

Nabeel Jafferali wrote:
I have an Audiocodes MP-118FXO in production. When a call is made and the 
remote party hangs up, the Audiocodes hangs up the call immediately. But if a 
call is received and the remote party hangs up, the Audiocodes does not hang up 
immediately.

Anyone experienced this issue with Audiocodes or any other gateway in general? 
Any tips?

--
Nabeel Jafferali
X2 Networks




---------------------------------------------------------------------
To unsubscribe, e-mail: [email protected]
For additional commands, e-mail: [email protected]


---------------------------------------------------------------------
To unsubscribe, e-mail: [email protected]
For additional commands, e-mail: [email protected]



---------------------------------------------------------------------
To unsubscribe, e-mail: [email protected]
For additional commands, e-mail: [email protected]

Reply via email to