atkinsonrr;141854 Wrote: > That was very helpful. Much appreciated! Once I get everything hooked > up, I will go for maximum volume and see how close that is to 0db. If > not very close, I plan to purchase a couple of Rothwell 10db > Attenuators I have scoped out at Audiogon. (Needed cause I will use > the balanced outs). I also have a PDF chart that shows resistance > values equated to db at different voltage and impedance. So, if 10db > does not get it close to a zero setting, I should be able to get it > dialed in by changing out resistors in the Rothwells. I don't know exactly how the Rothwells are constructed. Are the resistors easily swappable? If they are soldered in (which seems likely), and you are confident that you can change them, then it would be just as easy to work out the values you need and put them into the XLR plugs in your cables. And that way it will only cost you pennies. (The Rothwells seem very expensive to me, although I am sure they are well built).
-- cliveb Performers -> dozens of mixers and effects -> clipped/hypercompressed mastering -> you think a few extra ps of jitter matters? ------------------------------------------------------------------------ cliveb's Profile: http://forums.slimdevices.com/member.php?userid=348 View this thread: http://forums.slimdevices.com/showthread.php?t=28133 _______________________________________________ audiophiles mailing list [email protected] http://lists.slimdevices.com/lists/listinfo/audiophiles
