Thanks for the reply. I must admit that my knowledge in amps etc. is not as good as I would wish for.
I have tried to find out about the Lyngdorf's: - input sensitivity (less than 1.5V (less than 1V even better) - input impedance. (probably no lower than 10K and better if higher) - whether it has balanced inputs. - proper impendance and voltage ratios (amp/source) (also apply when using passive preamps like a TVC.) But I couldn't really figure it out from the below mentioned specs. Would the setup work or should I look for something else? _The_specs_for_the_DLS_R66_are:___Impedance 4 ohm Frequency range 40 Hz - 25 kHz Sensitivity 89 dB/1m, 1W Recommended amplifier 30 - 200 Watt Crossover point (Hz) 3500 Hz Crossover Bessel 1st / 2nd order, woofer 6dB _The_Lyngdorf_SDA_2175:_ Output power, 4 ohms 2 x 375 Watt 1KHz, 0.1% THD+N Output power, 8 ohms 2 x 200 Watt 1KHz, 0.1% THD+N Nominal load impedance 4 - 8 Ohms Frequency response 0.3Hz-33KHz -3dB points, 8ohms load. Frequency response 20Hz-20KHz -0dB/+0.2dB, 8ohms load Output impedance 0.035 Ohms 20Hz-1KHz Output impedance 0.4 Ohms 20KHz THD+N 0.004% @1W/8 ohms A-wgt. THD+N 0.006% @1 W/4 ohms A-wgt. THD+N 0.01% @100 W/8 ohms A-wgt. THD+N 0.07% @300 W/4 ohms A-wgt. S/N ratio 117dB A-wgt. Ref. 200 /8 ohms Dynamic range A-wgt. Ref. 200 W/8 ohms Channel separation 84 dB 1 KHz, 200 W/8 ohms Peak output current +/-40A Mains voltage range 100-120V AC, 50-60Hz 115 V version Mains voltage range 200-240V AC, 50-60Hz 230 V version Power consumption 1.5 W Standby mode Power consumption 35 W Operate mode, no output Power consumption 116 W 2 x 37.5 W / 4 Ohms Power consumption 820 W 2 x 300 W / 4 Ohms -- misterburns ------------------------------------------------------------------------ misterburns's Profile: http://forums.slimdevices.com/member.php?userid=21970 View this thread: http://forums.slimdevices.com/showthread.php?t=56628 _______________________________________________ audiophiles mailing list [email protected] http://lists.slimdevices.com/lists/listinfo/audiophiles
