Hello I have a model that is basically the same one that you see on the front page of my website http://deviantworkshop.com/. I expanded on this model by creating a hole in one of the circle rooms floors and it drops down to a complex that is below. Would there be a problem with the whole in the floor even though the drop is still enclosed by faces on the way down? The error messages I get are about there is a problem with the vertices but I have checked a rechecked the model. The only thing that I can think of is that it is the hole in the floor and prefab assumes that is an empty face. I converted it to a awd file and tried it again but I get the same errors.
You can get the model at http://www.deviantworkshop.com/complex/ Load awd file url [file:///C:/Users/cstratton/Documents/BlenderAway3dExsperiments/ HomeDungenGame/complex/Complex.awd] >> image aw_0.png loaded: 1024 x 1024 possible cause located at[-1961.530624160815,-1220.6754212915705,4793.283844302087] << BSP build ERROR: Empty faces were created. This could indicate the source geometry wasn't aligned properly to a grid. Thanks Christian
