On 09/15/2015 11:23 AM, Wayne Sallee wrote:
Looks like one has to recompile the kernal drivers after putting the firmware
into /lib/firmware.
I got better results after doing so.
I was getting some errors, but that cleared up later, so I thought it was from rebuilding the kernel drivers, but I
realized that I had just lost connection with the tail log.
The errors "rt2x00lib_rxdone_read_signal: Warning - Frame received with unrecognized signal" are still there, but
disconnecting and reconnecting the usb wireless helped.
The above error is a known problem with this wireless.
But anyway I seem to be connected, but, yet I can't connect to a website using link. Link works fine when the network
cable is used.
root [ ~ ]# ip link list
1: lo: <LOOPBACK,UP,LOWER_UP> mtu 65536 qdisc noqueue state UNKNOWN mode
DEFAULT group default
link/loopback 00:00:00:00:00:00 brd 00:00:00:00:00:00
2: eth0: <BROADCAST,MULTICAST,UP,LOWER_UP> mtu 1500 qdisc pfifo_fast state UP
mode DEFAULT group default qlen 1000
link/ether 08:00:27:df:5e:da brd ff:ff:ff:ff:ff:ff
3: sit0@NONE: <NOARP> mtu 1480 qdisc noop state DOWN mode DEFAULT group default
link/sit 0.0.0.0 brd 0.0.0.0
6: wlan0: <BROADCAST,MULTICAST,UP,LOWER_UP> mtu 1500 qdisc mq state UP mode
DORMANT group default qlen 1000
link/ether 00:1a:70:af:24:39 brd ff:ff:ff:ff:ff:ff
root [ ~ ]#
Wayne Sallee
wa...@waynesallee.com
--
http://lists.linuxfromscratch.org/listinfo/blfs-support
FAQ: http://www.linuxfromscratch.org/blfs/faq.html
Unsubscribe: See the above information page
