So far as I know these saws are about as bad as it gets for dust control. I suppose with enough vacuum anything is possible but the overhead nature of the saw means that the teeth lift dust arcing into the air. Some actually does make it's way into the dust bags but much of it flies all over the place, mostly away from the operator.
I built a cabinet with a hemicircular sort of baffle with a 4 inch hole in the bottom and a 1100 cu.ft. dust collector behind that as well as a tube from the dust port on the saw into that hole and it still doesn't collect all the dust.It does contain it so I can blow or brush much of it toward the extraction hole at intervals. Maybe a tent over the lot with a sleeve to accept the operators arm I don't know. The main disadvantage to a chop saw is the depth and width of cut, the capacity. If that meets your needs though they are quite cost effective. Now that dust control is becoming more of interest they may begin adding direct powered dust extraction right at the blade but I am not aware of that on any units yet. Dale Leavens, Cochrane Ontario Canada [EMAIL PROTECTED] Skype DaleLeavens Come and meet Aurora, Nakita and Nanook at our polar bear habitat. ----- Original Message ----- From: William Stephan To: [email protected] Sent: Sunday, January 13, 2008 3:44 PM Subject: RE: [BlindHandyMan] Chop saws was: miter boxes All: The time has come again to think about some kind of stationary saw. So, I'm thinking a chop saw might do pretty much all I need. I have some memories of these, but this is 25 plus years ago. My recollection is that these were made with a sort of tub you actually did your cutting in. And, if that's right, it would seem you could control dust easier with that kind of set up than with a normal table saw. Am I remembering this right? And, is it in fact easier to control dust with one of these? Thanks. -----Original Message----- From: [email protected] [mailto:[EMAIL PROTECTED] On Behalf Of [EMAIL PROTECTED] Sent: Sunday, January 13, 2008 2:33 AM To: [email protected] Subject: Re: [BlindHandyMan] miter boxes I need to replace mine. I don't see chop-saw money here anytime soon. The one I have is actually plasticand has served for just under 10 years. Are there some that are especially worth paying considerably more? Something metal, with adjustments? Curious. On Sat, 12 Jan 2008, Bob Kennedy wrote: > They are fine as a guide. Although you can get away without one, you need to use a back saw with a miter box because it is stiffer and won't flex when cutting. > ----- Original Message ----- > From: Shane Hecker > To: blindhandyman@ <mailto:blindhandyman%40yahoogroups.com> yahoogroups.com > Sent: Saturday, January 12, 2008 12:53 AM > Subject: [BlindHandyMan] miter boxes > > > What do you think of the miter boxes? Has anyone used them? Just wondering > as my mother's husband got me one. > > Shane > > > > > > [Non-text portions of this message have been removed] > > [Non-text portions of this message have been removed] [Non-text portions of this message have been removed]
