Well, if you have two people there, you can gently tug it out from away from
the wall and have you or the other person hold it out while it is cut and then
you might only have to put back a nail or two. Depending on how old it is,
just be careful not to pull on it with too much pressure so it doesn't snap on
you.
Eric
----- Original Message -----
From: Alan & Terrie Robbins
To: Blindhandyman
Sent: Friday, November 20, 2009 3:55 PM
Subject: [BlindHandyMan] Tool selection
Looking for suggestions on what type of tool I need to
accomplish the below.
I have a 3 to 4 inch wide piece of molding in my garage
that runs the length of it (approximately 25 feet) that
separates the concrete block wall with the sheetrock
ceiling. I need to cut about 2 feet or so off of one end but
do not want to take the whole thing down and then put up
again. I think some type of a wheel cutting device on a
drill or something may work but looking for ideas
thanks
Al
[Non-text portions of this message have been removed]
