Well similiar to Erics suggestion. Start removing the molding from the end you
are wanting to cut off . Slip a block of wood under the space you create as
you are prying it up. Then you can carefully cut it with a hand saw, but the
wedge under gives you a little more to manuver the saw. Just take time with it.
Ron
----- Original Message -----
From: Alan & Terrie Robbins
To: Blindhandyman
Sent: Friday, November 20, 2009 2:55 PM
Subject: [BlindHandyMan] Tool selection
Looking for suggestions on what type of tool I need to
accomplish the below.
I have a 3 to 4 inch wide piece of molding in my garage
that runs the length of it (approximately 25 feet) that
separates the concrete block wall with the sheetrock
ceiling. I need to cut about 2 feet or so off of one end but
do not want to take the whole thing down and then put up
again. I think some type of a wheel cutting device on a
drill or something may work but looking for ideas
thanks
Al
[Non-text portions of this message have been removed]
