A router would do it. Just be sure your bit depth doesn't cut into the sheet rock.
earlier, Alan & Terrie Robbins, wrote: > > >Looking for suggestions on what type of tool I need to >accomplish the below. >I have a 3 to 4 inch wide piece of molding in my garage >that runs the length of it (approximately 25 feet) that >separates the concrete block wall with the sheetrock >ceiling. I need to cut about 2 feet or so off of one end but >do not want to take the whole thing down and then put up >again. I think some type of a wheel cutting device on a >drill or something may work but looking for ideas > >thanks >Al > > John [Non-text portions of this message have been removed]
