Hi! I use a Braille Blazer, and haven't checked it out yet. When I get another serial cable, I probably will. I know one thing, in looking at the embosser setup, the baud rate, the stop bits, and the parity must be the same on both devices. That's one real important key. Also, when you're setting up the embosser on the braille note, you need a right margin of about 33, and a left margin of 1. At least, that's what I use. What else is needed, I'm not sure. I'll get brave one of these days and find out!
Martha Loescher, Secretary ODNR Division of Watercraft 2045 Morse Rd Bldg A-3 Columbus OH 43229 Phone: 614-265-6774 Email: [EMAIL PROTECTED] -----Original Message----- From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED] On Behalf Of Rhonda Clark Sent: Tuesday, April 18, 2006 2:14 PM To: BrailleNote List Subject: [Braillenote] Braille Blazer Are any of you using the Braille Blazer, and if so, what is required? Also, what kind of success are you having? Thanks in advance. ___ To leave the BrailleNote list, send a blank message to [EMAIL PROTECTED] To view the list archives or change your preferences, visit http://list.humanware.com/mailman/listinfo/braillenote ___ To leave the BrailleNote list, send a blank message to [EMAIL PROTECTED] To view the list archives or change your preferences, visit http://list.humanware.com/mailman/listinfo/braillenote
