Hello,
I am using the Braille Blazer with my Mpower. I have an Mpower
running version 7. I am running it via serial port. I have two
adapters on the cord to make it work. On the end of the cord is
a 9 pin to 25 pin adapter. Then there is the 25 pin to 25 pin
adapter. I never can remember which is male and which is female,
but the 25 pin to 25 pin both have the pins which can be felt.
My 9 to 25 pin adapter has the holes so I had to add the adapter
with pins on both sides so the mpower would connect to the
blazer. Then set up the serial parameters on both machines 9600
baud, 8 data bits, no parity and software handshaking. You also
need to select the braille table in the set-up list. I have my
page length set to 25 right margin 32 offset 1. Since I don't
have the blazer set up right now I can't check the settings. But
it does work. Now if I could get bluetooth and the computer to
work.
Sue Mangis
----- Original Message -----
From: Rhonda Clark <[EMAIL PROTECTED]
To: BrailleNote List <[email protected]
Date: Tue, 18 Apr 2006 13:14:04 -0500
Subject: [Braillenote] Braille Blazer
Are any of you using the Braille Blazer, and if so, what is
required? Also, what kind of success are you having?
Thanks in advance.
___
To leave the BrailleNote list, send a blank message to
[EMAIL PROTECTED]
To view the list archives or change your preferences, visit
http://list.humanware.com/mailman/listinfo/braillenote
___
To leave the BrailleNote list, send a blank message to
[EMAIL PROTECTED]
To view the list archives or change your preferences, visit
http://list.humanware.com/mailman/listinfo/braillenote
