With the help of Barry L and Rob C, I replaced my controller. (I had left a few voicemail messages at WLL tech support and sent an email to Todd, but had no response, so I ordered a generic one from Canada yesterday, which arrived today.) I set it up with parameters which were provided by Barry and Rob (only minimally different). After the unit overheated and gave me an E1 error, I replaced the temperature probe with a new one, but the same E1 error code appeared. Oy!!
So, where do I go from here? Here are the parameters that I was given: C0= -5 CO -7 C1= 1 C1 99 (I think this is in error, as the parameter only goes up to 20) C2= 99 C2 99 C3 = -45 C3 -50 C4 = 1 C4 0 C5 = 0 C5 0 C7 = 0 C7 0 C8 = 1 C8 1 d0 = 1 DO 1 d1 = 0 D1 0 d2 = 2 D2 2 d3 = 5 D3 5 L5 = 0 L5 0 L6 = 0 L6 0 PU = 0 PU 0 P0 = 0 PO 1 P1 - P7 = 0 P1-P7 0 These are all pretty close except for the C0 and the C1 values Does anyone have any thoughts about what could be wrong? I find it hard to believe that two major things went wrong at the same time, but I am wondering if, in fact, they are related.. Thanks! Ken K My apologies if this is similar to what I thought I had posted earlier but which did not show up after a couple of hours.... at least this one has the values for the controller parameters... --~--~---------~--~----~------------~-------~--~----~ You received this message because you are subscribed to the Google Groups "Brewtus" group. To post to this group, send email to [email protected] To unsubscribe from this group, send email to [email protected] For more options, visit this group at http://groups.google.com/group/brewtus?hl=en -~----------~----~----~----~------~----~------~--~---
